Brother dcp-9045cdn User Manual page 88

Error Message
Change Parts
PF kit MP
Change Parts
PF kit 1
Change Parts
PF kit 2
Change Parts
Waste Toner Box
Check Paper Size
Reload correct
paper.
Cooling Down
Wait for a while
Cover is Open
Close the Front
Cover.
Cover is Open
Close the Back
Cover.
Document Jam
Drum Error
EL Error
Fuser Error
80
Cause
It is time to replace the paper
feeding kit for the MP tray.
It is time to replace the paper
feeding kit for Tray 1.
It is time to replace the paper
feeding kit for Tray 2.
The waste toner box is almost full. Be ready to replace the waste toner box. (See
The paper in the tray is not the
correct size.
The temperature of the drum unit
or toner cartridge is too hot. The
machine will pause its current
print job and go into cooling down
mode. During the cooling down
mode, you will hear the cooling
fan running while the LCD shows
Cooling Down, and
Wait for a while.
The front cover is not closed
completely.
The back cover is not closed
completely.
The document was not inserted
or fed properly, or the document
scanned from the ADF was too
long.
The corona wires on the drum
unit need to be cleaned.
The machine has a mechanical
problem.
The temperature of fuser unit
does not rise at a specified
temperature within specified time.
The fuser unit is too hot.
Action
Call your Brother dealer to purchase the
PF Kit MP.
Call your Brother dealer Service to purchase
the PF Kit 1.
Call your Brother dealer Service to purchase
the PF Kit 2.
Replacing the waste toner box on page 132.)
Load the correct size of paper in the tray and
set the "Paper Size" (Menu, 1,2) and "Tray
Use"(Menu, 1,6). (See Paper size
on page 20,Tray use in copy mode
on page 21,Tray use in print mode
on page 21.)
Make sure that you can hear the fan in the
machine spinning and that the exhaust outlet
isn't blocked.
If the fan is spinning, remove any obstacles
that surround the exhaust outlet, and then
leave the machine turned on but do not use it
for several minutes.
If the fan is not spinning follow the suggestions
below.
Turn off the machine's power switch and then
turn it on again. If the error message continues
leave the machine for several minutes and
then try it again.
Close the front cover of the machine.
Close the back cover of the machine.
See Document jams on page 84 or Using the
ADF (automatic document feeder)
on page 18.
Clean the four corona wires on the drum unit.
(See Cleaning the corona wires on page 102.)
Open the front cover and close it again.
Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine
for 15 minutes with the power on.