Error Messages - Onkyo HT-RC160 Instruction Manual

First Time Setup—Continued
10
Disconnect the speaker setup
microphone.
Notes:
• When the room correction and speaker setup is
complete, the "Equalizer Settings" (page 69) will be
set to "Audyssey" and the "Dynamic EQ" (page 71)
will be set to "On".
• You can cancel the Room Correction and Speaker
Setup at any point in this procedure simply by
disconnecting the setup microphone.

Error Messages

While the room correction and speaker setup is in
progress, one of the following error messages may
appear:
❏ Ambient noise is too high.
Retry
Cancel
This message appears if the background noise is too
loud and the measurements cannot be performed
properly.
Remove the source of the noise and try again.
Retry: Return to the measured point immediately
before and start set up again.
Cancel: Cancel the room correction and speaker setup.
48
2EQ: Auto Setup
Please unplug setup microphone.
2EQ: Auto Setup
Ambient noise is too high.
❏ Speaker Detect Error
This message appears if a speaker is not detected. "Yes"
means that a speaker was detected. "No" means that no
speaker was detected.
2EQ: Auto Setup
Speaker Detect Error
FL : Yes
SL : ---
FHL : ---
SBL : ---
C : Yes
Retry
Cancel
One of the front speakers has not been detected.
2EQ: Auto Setup
Speaker Detect Error
FL : Yes
SL : ---
FHL : ---
SBL : ---
C : Yes
Retry
Cancel
One of the surround speakers has not been detected.
2EQ: Auto Setup
Speaker Detect Error
FL : Yes
SL : ---
FHL : ---
SBL : ---
C : Yes
Retry
Cancel
The surround back speakers have been detected but
the surround speakers haven't.
2EQ: Auto Setup
Speaker Detect Error
FL : Yes
SL : ---
FHL : ---
SBL : No
C : Yes
Retry
Cancel
The right surround back speaker has been detected
but the left surround back speaker hasn't.
2EQ: Auto Setup
Speaker Detect Error
FL : Error
SL : Yes
FHL : ---
SBL : Yes
C : Yes
Retry
Cancel
The speaker type detected does not match what was
expected. The speaker may be or incorrect type or
broken. Please check that it is the correct speaker
type, or that all drivers are working.
FR : No
SR : ---
FHR : ---
SBR : ---
SW : ---
FR : Yes
SR : No
FHR : ---
SBR : ---
SW : ---
FR : Yes
SR : No
FHR : ---
SBR : Yes
SW : ---
FR : Yes
SR : Yes
FHR : ---
SBR : Yes
SW : ---
FR : Yes
SR : Yes
FHR : ---
SBR : Yes
SW : Yes