Installing The Front And Rear Wheels; Installing The Steering Wheel; Removing The Battery From The Chassis; Installing The Seat - Toro 30630 Groundsmaster 328-D Operator's Manual

Note: Some models may have already been set–up at
factory.
Installing the Front and Rear
Wheels
1. Remove and discard fasteners securing wheels to
packaging.
2. Remove wheel nuts from studs on axles.
3. Mount wheels and torque mounting nuts to 45-55 ft.-lb.
(61-75 N m).

Installing the Steering Wheel

1. Move rear wheels so they point straight ahead.
2. Remove jam nut from steering shaft. Slide foam seal
and steering wheel onto steering shaft (Fig. 2).
Figure 2
1. Steering wheel
2. Jam nut
3. Cap
3. Secure steering wheel to shaft with jam nut and tighten
it to 10–15 ft.-lb.
4. Install cap to steering wheel with screw (Fig. 2).
Removing the Battery from the
Chassis
1. Release the two latches holding instrument cover in
place. Carefully remove instrument cover to expose the
battery.
4
3
2
1
5
4. Screw
5. Foam seal
15
2. Remove two wing nuts and hold down strap that secures
battery (Fig. 3). Lift battery out of chassis. Keep wing
nuts and hold down strap in safe place for later use.
1
2
Figure 3
1. Wing nuts
2. Hold down strap

Installing the Seat

The machine is shipped without the seat assembly. Either
optional Seat Kit, Model No. 30623 or 30625 must be
installed.
Seat Kit, Model No. 30623, Standard Seat
1. Loosely secure (2) R-clamps to right side of seat bottom
with 2 capscrews and flat washers supplied in kit
(Fig. 4). Install manual tube into R-clamps and tighten
capscrews (Fig. 4).
Figure 4
1. R-clamps
2. Seat support
1
4
3
3. Positive terminal
4. Negative terminal
3. Manual tube
4. Cap