Table of Contents
Advertisement
Glow Plug Indicator Light
When lit, the glow plug indicator light (Fig. 24) indicates
that the glow plugs are on.
Engine Temperature Gauge
This gauge (Fig. 24) indicates the engine coolant
temperature.
Speed Limiter
Adjust the screw (Fig. 25) to limit the amount the traction
pedal can be depressed in the forward direction to limit
speed.
Important
The traction pedal must contact the speed
limiter before reaching the end of the pump stroke to
prevent pump damage
Figure 25
1. Speed limiter
Lift Levers
The levers (Fig. 26) raise and lower the cutting units.
Important
The center lift lever must momentarily be
pushed to the lower position to enable PTO circuit
actuation by PTO switch.
Cutting Unit Service Lock
The cutting unit service lock (Fig. 26) prevents the center
cutting unit lift lever from lowering the cutting unit when it
is in the raised position.
Key Switch
The key switch (Fig. 26) has three positions: Off,
On/Preheat, and Start.
PTO Switch
The PTO switch (Fig. 26) has three positions: Engage,
Neutral and Disengage. Carefully lift and push the PTO
switch forward to the Engage position to start the
implement or cutting unit blades. Slowly pull the switch
backward to the Disengage position to stop implement
operation.
Important
pushed to the lower position to enable PTO circuit
actuation by PTO switch.
Hi-Lo Speed Control
The control (Fig. 26) allows the speed range to increase for
transport of the machine.
1
2
2
1. Lift lever
2. Front cutting unit service
lock
3. Key switch
4. PTO switch
5. Hi-lo speed control
6. Cruise control (optional)
25
The center lift lever must momentarily be
7
6
4 5
1
10
11
3
13
Figure 26
7. Alarm silence switch
8. Temperature reset switch
9. Hour meter
10. Fuel gauge
11. Throttle
12. Audible alarm
13. Power point
8
12
9
Advertisement
Table of Contents
