Glow Plug Indicator Light
When lit, the glow plug indicator light (Figure 2)
indicates that the glow plugs are on.
Engine Temperature Gauge
This gauge (Figure 2) indicates the engine coolant
temperature.
Speed Limiter
If desired, the screw can be adjusted (Figure 3) to limit
the amount the traction pedal can be depressed in the
forward direction to limit the mowing speed.
Important: The traction pedal must contact the
speed limiter before reaching the end of the pump
stroke to prevent pump damage.
1. Speed limiter
Lift Levers
The levers (Figure 4) raise and lower the cutting units.
Cutting Unit Service Lock
The cutting unit service lock (Figure 4) locks the front
cutting unit lift lever when the cutting unit is in the
raised position.
Key Switch
The key switch (Figure 4) has three positions: Off,
On/Preheat, and Start.
Figure 3
PTO Switch
The PTO switch (Figure 4) has three positions: On
(engage), Neutral, and Off (disengage). Carefully lift
and push the PTO switch forward to the On position
to start the implement or cutting unit blades. Slowly
pull the switch backward to the Off position to stop
implement operation.
Hi-Lo Speed Control
The control (Figure 4) allows the speed range to increase
for transport of the machine.
Flow Divider Switch
When operating in mow (low) speed, press and hold
flow divider switch (Figure 4) to enhance traction drive
performance in compromised operating conditions.
1. Lift lever
2. Front cutting unit service
lock
3. Key switch
4. PTO switch
5. Hi-lo speed control
6. Flow divider switch
7. Cruise control (optional)
Cruise Control (Optional)
The cruise control (Figure 4) sets the speed of the
machine.
Fuel Gauge
The fuel gauge (Figure 4) indicates the level of fuel in
the tank.
Hour Meter
The hour meter (Figure 4) shows the total hours that the
machine has been operated.
16
Figure 4
8. Alarm silence switch
9. Temperature reset switch
10. Hour meter
11. Fuel gauge
12. Throttle
13. Audible alarm
14. Power point