Maintenance; Recommended Maintenance Schedule - Toro 30789 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule

Maintenance Service
Interval
After first 10 hours
After first 50 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 400 hours
Every 1000 hours or 2
years, whichever occurs
first
Important Refer to your engine operator's manual for additional maintenance procedures.
Maintenance Procedure
Check the PTO belt tension.
Check the fan and alternator belt tension.
Change the transmission filter.
Torque the wheel lug nuts.
Change the engine oil and filter.
Check the PTO belt tension.
Torque head, adjust valves and check engine RPM.
Check the battery electrolyte level.
Check the battery cable connections.
Lubricate all grease fittings.
Lubricate the brake cables.
Check the cutting unit gear box oil level.
Clean under the cutting unit belt covers.
Check the cutting unit drive belt adjustment.
Check the PTO belt tension.
Inspect the air filter, dust cup and baffle.
Change the engine oil and filter.
Check the fan and alternator belt tension.
Inspect the cooling system hoses.
Change the transmission filter.
Service the air filter.
Check governor oil level
Decarbon spark arrestor muffler.
Check rear wheel toe-in and steering linkage.
Torque the wheel lug nuts.
Replace the cutting unit gear box oil.
Change fuel filter.
Replace spark plugs
Pack the rear wheel bearings.
Torque head, adjust valves and check engine RPM.
Replace moving hoses.
Replace safety switches.
Flush and replace the coolant system fluid.
Replace the hydraulic fluid.
27