Lubricating The Machine - Toro 30789 Operator's Manual

Lubricating the Machine

The traction unit must be lubricated regularly. If machine is
operated under normal conditions, lubricate all bearings
and bushings after every 50 hours of operation.
The traction unit bearings and bushings that must be
lubricated are:
All Models
PTO shaft and yokes (3) (Fig. 21)
Lift arm pivots (Fig. 21)
Right and left push arm ball joints (Fig. 21)
Push arm pivot bushings (Fig. 22)
PTO pivot housing blocks (Fig. 23)
Brake pivot bushings (Fig. 24);
Engine output shaft bearing (Fig. 25)
Rear wheel spindle bushings (Fig. 26)
Steering plate bushings (Fig. 26)
Axle pin bushing (Fig. 26)
Note: Apply grease to both brake cables at the drive wheel
and brake pedal ends.
Figure 21
Figure 22
(3)
29
Figure 23
Figure 24
Figure 25
Figure 26