Installing The Steering Wheel; Removing The Battery From The Chassis; Installing The Seat - Toro 30789 Operator's Manual

Installing the Steering Wheel

1. Move rear wheels so they point straight ahead.
2. Remove jam nut from steering shaft. Slide foam seal
and steering wheel onto steering shaft (Fig. 2).
3. Secure steering wheel to shaft with jam nut and tighten
it to 10–15 ft.-lb.
4. Install cap to steering wheel with screw (Fig. 2).
Figure 2
1. Steering wheel
2. Jam nut
3. Cap
Removing the Battery from the
Chassis
1. Release the two latches holding instrument cover in
place. Carefully remove instrument cover to expose the
battery.
2. Remove two wing nuts and hold down strap that secures
battery (Fig. 3). Lift battery out of chassis. Keep wing
nuts and hold down strap in safe place for later use.
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
4
3
2
1
5
4. Screw
5. Foam seal
14
4
Figure 3
1. Wing nuts
2. Hold down strap

Installing the Seat

The machine is shipped without the seat assembly. Either
optional Seat Kit, Model No. 30623 or 30625 must be
installed.
Seat Kit, Model No. 30623, Standard Seat
1. Loosely secure (2) R-clamps to right side of seat bottom
with 2 capscrews and flat washers supplied in kit
(Fig. 4). Install manual tube into R-clamps and tighten
capscrews (Fig. 4).
Figure 4
1. R-clamps
2. Seat support
2. Mount seat pivot bracket to frame with 2 flange screws
supplied in kit (Fig. 5)
3
2
1
3. Positive terminal
4. Negative terminal
2
3
1
4
3. Manual tube
4. Cap