Figure 43
1. Transmission-case drain
plug
2. Filter
4. Clean the area around the hydraulic-fluid filter and
remove the filter
(Figure
5. Immediately install a new hydraulic-fluid filter.
6. Install the drain plugs in the hydraulic reservoir and
the transmission case.
7. Fill the reservoir to the proper level; refer to
the Hydraulic System (page
8. Start the engine and check for fluid leaks. Allow the
engine to run for about 5 minutes, then shut it off.
9. After 2 minutes, check the level of the hydraulic fluid;
refer to
Checking the Hydraulic System (page
3. Hydraulic-reservoir drain
plug
43).
Checking
42).
42).
Cleaning
Waste Disposal
Engine oil, batteries, hydraulic fluid, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.
43