Upper Grille Assembly; Control Panel - Viking VDSC367 Service Notebook

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless
test procedures require power to be connected. Ensure all ground wires are connected before certifying unit as
repaired and/or operational.

Upper Grille Assembly

Removal of the upper grille assembly allows
access to the control assembly.
1. To remove the upper grille assembly, slide
out the middle air louver.
Middle Air Louver
2. With the middle grille louver removed,
remove the (2) 1/4" hex screws securing
the grille assembly.
Remove 1/4" screw
on each side
3. Remove the grille assembly
©2012 Viking Preferred Service
! WARNING

Control Panel

The control panel has an overlay switch
attached to it that allows user input to the
control boards.
1. To access the control panel, remove the
upper air grill assembly (see Upper Grill
Removal section), remove (2) screws
securing the control panel.
2. Pull control panel from securing tabs.
3. Lower the control panel. Take caution with
the ribbon cable to prevent damage.
Disassembly
Screws
Securing tab
Securing tab
13