Changing The Engine Oil - Toro GrandStand 74583 Operator's Manual

Changing the Engine Oil

Service Interval: Every 100 hours (more often in dirty or
dusty conditions)
Note: Dispose of the used oil at a recycling center.
1. Park the machine so that the rear is slightly lower than
the front to ensure the oil drains completely.
2. Disengage the PTO, move the motion-control levers to
the neutral-locked position and set the parking brake.
3. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 43).
1
3
4
Figure 43
2
4
5
G008793
4. Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil to
bring it to the Full mark
1
3
5
5. Start the engine and drive to a flat area.
6. Check the oil level again.
34
(Figure 44).
2
4
6
G008796
Figure 44