Servicing The Fuses - Toro GrandStand 74583 Operator's Manual

Installing the Battery
1. Place the battery onto the machine
2. Secure the battery with the hold down plate, j-bolts,
and locknuts.
3. Install the positive (red) battery cable to positive (+)
battery terminal with a nut, a washer, and a bolt
51).
4. Slide the rubber cover over the post.
5. Install the negative battery cable and the ground wire
to the negative (-) battery terminal with a nut, a washer,
and a bolt (Figure 51).
6. Slide the rubber cover over the post.
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged
(1.265 specific gravity) to prevent battery damage when
the temperature is below 32°F (0°C).
1. Remove the battery from the chassis; refer to
the Battery (page 38).
2. Check the electrolyte level.
3. Ensure that the filler caps are installed on the battery.
4. Charge the battery for 1 hour at 25 to 30 amps or 6
hours at 4 to 6 amps.
5. When the battery is fully charged, unplug the charger
from the electrical outlet, and disconnect the charger
leads from the battery posts
6. Install the battery onto the machine and connect the
battery cables; refer to
Note: Do not run the machine with the battery
disconnected; electrical damage may occur.
(Figure 51).
(Figure
Removing
(Figure 52).
Installing the Battery (page
1. Positive Battery Post
2. Negative Battery Post

Servicing the Fuses

The electrical system is protected by fuses, and requires no
maintenance. If a fuse blows, check the component or circuit
for a malfunction or short.
1. Release the cushion from the rear of the machine.
2. Pull out on the fuse to remove or replace it
3. Install the cushion to the rear of the machine.
Note: Ensure that the correct-size fuse is installed
Figure 53.
39).
1
1. Fuses
39
Figure 52
3. Red (+) Charger Lead
4. Black (-) Charger Lead
(Figure
Figure 53
53).
g017915