Replacing The Pump-Drive Belt - Toro GrandStand 74583 Operator's Manual

g017890
1. 16.5 cm (6.5 inches) from
hook to hook
2. Spring
3. Spring-loaded idler

Replacing the Pump-drive Belt

Service Interval: Every 100 hours—Check the pump-drive
belt.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the mower-deck belt.
4. Tilt the machine; refer to
(page 28).
5. Remove the shoulder bolt, the nut, and the washer
from the engine deck and connected spring
Figure 75
4. Ratchet
5. Square hole for ratchet
6. Nut
Raising the Mower for Access
(Figure
5
4
1. Hydraulic pumps
2. Idler pulley
3. Clutch pulley
6. Remove the pump-drive belt
7. Install the new belt around the clutch and the 2 pump
pulleys.
8. Install the spring onto the shoulder bolt and washer,
and connect it to the engine deck with the nut
76).
9. Lower the machine to the operating position.
76).
10. Install the mower-deck belt.
50
6
1
G015402
Figure 76
4. Clutch retainer
5. Pump-drive belt
6. Shoulder bolt, nut, and
washer
(Figure 76).
2
3
(Figure