Adding Fuel To The Machine - Toro 74253 Setup Instructions

Figure 8
5. Raise the roll bar into the upright position and
secure it with the pins and hairpin cotter pins
fastened to the lanyards
Figure 9
6. Torque all lower fasteners, attached to the
machine frame, to 30 ft-lb (41 N⋅m).
7. Tighten the center roll bar bolts (1/2 x 3-1/4
inch) so it rotates freely with some resistance.
Note: No more than one thread should be
exposed outside the nut.
Figure 10
Step
5

Adding Fuel to the Machine

No Parts Required
Procedure
Add gasoline to the machine before starting it.
Refer to your Operator's Manual. for the correct fuel
and procedure.
4