Removing The Machine From The Crate; Servicing The Hydraulic Fluid; Adding Fuel To The Machine; Checking The Engine Oil Level - Toro Z Master Professional 2000 Series Setup Instructions

1
Removing the Machine
from the Crate
No Parts Required
Procedure
If removing the machine from a metal crate, refer to
the Dealer/Distributor Portal for further information.
2

Adding Fuel to the Machine

No Parts Required
Procedure
Add fuel to the machine before starting it. Refer
to your Operator's Manual for the correct fuel and
procedure.
3
Checking the Engine-Oil
Level
No Parts Required
Procedure
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer
to Servicing the Engine-Oil Level in the Operator's
Manual.
4
Servicing the Hydraulic
Fluid
No Parts Required
Procedure
This machine is shipped filled with hydraulic fluid in
the reservoirs.
Check the expansion tank; if necessary, add Toro
HYPR-OIL ™ 500 hydraulic fluid, as recommended in
the Operator's Manual, to the FULL COLD line
1).
1. Engine
2
Figure 1
2. Expansion tank
®
(Figure
g037051