Using The Door Control; Programming - Push Button Door Control - Chamberlain 8160 User Manual

Operation

Using the Door Control

SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door
opener, press the push bar or push button until the
garage door opener activates (it may take up to 3
presses). Test the door control by pressing the push
bar or push button, each press of the push bar or push
button will activate the garage door opener.
Push Bar
Push
Button
PUSH BAR OR PUSH BUTTON
Press the push bar or push button to open or close the
door.
LIGHT BUTTON
Press the LIGHT button to turn the garage door opener
lights on or off. When the lights are turned on they will
stay on until the LIGHT button is pressed again, or until
the garage door opener is activated. Once the garage
door opener is activated the lights will turn off after the
specifi ed period of time (the factory setting is 4-1/2
minutes). The LIGHT button will not control the lights
when the door is in motion.
The following features are accessible by lifting the
push bar (multi-function door control only):
LEARN A DEVICE
Any compatible remote controls or wireless keyless
entries can be programmed to the garage door opener by
pressing the LEARN button on the Multi-Function Control
Panel.
SERVICE
LED
LEARN
Button
LOCK
Button
COMMAND
LED
LIGHT
Button
Light
Button
LOCK
The LOCK feature is designed to prevent activation of
the garage door opener from remote controls while still
allowing activation from the door control and keyless
entry. This feature is useful for added peace of mind
when the home is empty (i.e. vacation).
AUTOMATIC LIGHT
Light Feature
The lights will turn on when someone enters through
the open garage door and the safety reversing sensor
infrared beam is broken.
MAINTENANCE ALERT SYSTEM (MAS)
This feature assists the homeowner in ensuring the
garage door opener system stays in good working
condition. When the garage door opener needs to be
serviced (approximately 4500 garage door opener cycles)
the command (yellow) and service (red) LEDs will begin
to alternately fl ash back and forth. The factory setting for
the MAS feature is off and can be activated at time of
installation. Contact your installing dealer for service.
Programming - Push Button Door
Control
Push
Button
Feature
To Program 1. Press and hold the Light button and
a Remote the Push button until the Push button
Control or LED begins to blink.
Keyless
2. Remote Control: Press the button on
Entry
the remote control that you wish to
operate your garage door.
Keyless Entry: Enter a 4-digit personal
identifi cation number (PIN) of your
choice on the keyless entry keypad.
Then press the ENTER button.
The garage door opener lights will fl ash
(or two clicks will be heard) when the
code has been programmed.
6
Light
Button