Programming - Remote Controls; To Erase The Memory - Chamberlain 8160 User Manual

Operation

Programming - Remote Controls

Your garage door opener has been programmed at the factory to operate with your remote control. Older LiftMaster
remote controls are NOT compatible. Programming can be done through the door control or the Learn button on the
garage door opener. To program additional remote controls refer to the instructions provided with the additional remote
controls or visit LiftMaster.com. If your vehicle is equipped with HomeLink
may be necessary for certain vehicles. Visit bridge.LiftMaster.com to fi nd out if a Bridge is needed.
NOTE: The products illustrated in the instructions are for reference. Your product may look different.
PROGRAM A REMOTE USING THE LEARN BUTTON ON THE GARAGE DOOR OPENER
1
Locate the Learn button.
3
Press and hold the button on the remote control that
you wish to use.
Release the button when the garage door opener
lights blink or two clicks are heard.
If programming to other products, press the button a
second time to activate products.
ERASE ALL DEVICES (INCLUDING MYQ
1
Press and hold the learn button on garage door opener until the learn LED goes out (approximately 6 seconds).
2
Immediately press and hold the learn button again until the learn LED goes out. All codes are now erased.
Reprogram any accessory you wish to use.
ENABLED ACCESSORIES)
®
8
, a Compatability Bridge
®
2
Press and immediately release the Learn button.
The Learn LED will glow steady for 30 seconds.
Within 30 seconds...
(not included)
TM