Sound Pressure Level; Sound Power Level; Vibration Level - Toro 03660 Operator's Manual

Two-wheel drive traction units

Hide thumbs

Table Of Contents

Table of Contents

– Do not drive close to sand traps, ditches, creeks,

or other hazards.

– Reduce speed when making sharp turns. Avoid

sudden stops and starts.

– When near or crossing roads, always yield the

right-of-way.

– Apply the service brakes when going downhill to

keep forward speed slow and to maintain control

of the machine.

• Raise the cutting units when driving from one work

area to another.

• Do not touch the engine, silencer/muffler, or

exhaust pipe while the engine is running or soon

after it has stopped because these areas could be hot

enough to cause burns.

• If the engine stalls or loses headway and cannot make

it to the top of a slope, do not turn the machine

around. Always back slowly, straight down the slope.

• When a person or pet appears unexpectedly in

or near the mowing area, stop mowing. Careless

operation, combined with terrain angles, ricochets,

or improperly positioned guards can lead to thrown

object injuries. Do not resume mowing until the

area is cleared.

Maintenance and Storage

• Make sure all hydraulic line connectors are tight and

all hydraulic hoses and lines are in good condition

before applying pressure to the system.

• Keep your body and hands away from pin hole

leaks or nozzles that eject hydraulic fluid under

high pressure. Use paper or cardboard, not your

hands, to search for leaks. Hydraulic fluid escaping

under pressure can have sufficient force to penetrate

the skin and cause serious injury. Seek immediate

medical attention if fluid is injected into skin.

• Before disconnecting or performing any work on

the hydraulic system, all pressure in the system must

be relieved by stopping the engine and lowering the

cutting units and attachments to the ground.

• Check all fuel lines for tightness and wear on a

regular basis. Tighten or repair them as needed.

• If the engine must be running to perform a

maintenance adjustment, keep hands, feet, clothing,

and any parts of the body away from the cutting

units, attachments, and any moving parts. Keep

everyone away.

• To ensure safety and accuracy, have an Authorized

Toro Distributor check the maximum engine speed

with a tachometer. Maximum governed engine speed

should be 3200 RPM.

• If major repairs are ever needed or if assistance is

desired, contact an Authorized Toro Distributor.

• Use only Toro-approved attachments and

replacement parts. The warranty may be voided if

used with unapproved attachments.