Setup; Adjusting The Tire Pressure; Adjusting The Step Height; Figure - Toro 03660 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Adjusting the Tire Pressure

No Parts Required
Procedure
The tires are over-inflated for shipping. Therefore,
release some of the air to reduce the pressure. Correct
air pressure in the front and rear tires is 12 to 15 psi (83
to 103 kPa).
Important: Maintain even pressure in all tires to
ensure uniform contact with the turf.
Description
No parts required
No parts required
No parts required
Front hose guide-R.H.
Front hose guide-L.H.
No parts required
Rear weights (size varies with
configuration).
Hood latch assembly
Washer
Cutting unit kickstand
Gauge bar
Operator's Manual
Engine Operator's Manual
Parts Catalog
CE certificate
Operator Training Material
Qty.
–
Adjust the tire pressure.
–
Adjust the step height.
–
Adjust the control arm position.
1
Install the cutting units
1
–
Adjust the turf compensation spring.
Install rear weights (order from your
Varies
Toro Distributor).
1
Install the CE Hood Latch
1
1 Install the Cutting Unit Kickstand.
Use the gauge bar to adjust the cutting
1
unit.
1
1
Read the Operator's Manual and watch
1
the video before operating the machine.
1
1
2

Adjusting the Step Height

No Parts Required
Procedure
The height of the steps can be adjusted for the operators
comfort.
1. Remove the 2 bolts and nuts securing the step
brackets to the traction unit frame (Figure 2)
12
Use