Install Front Wheels; Install Rear Wheels; Check Tire Pressure - Toro 72071 Setup Instructions

Set Up Instructions

Install Front Wheels

Note: If wheels are already installed, refer to
Check Tire Pressure (below).
1. Slide wheel onto axle with valve stem in.
(Fig. 1).
2. Wheel end play should be 0-.015" (0-.4 mm).
Use shim washers (as required) and large OD flat
washer for spacing on the axle. Insert cotter pin
through the axle and bend the ends of the pin
open (Fig. 1).
3. Push the dust cover (Fig. 1) onto the end of the
axle so it snaps over washer.
Figure 1
1. Wheel
2. Shim washers (as
required)
4. Repeat steps 1–3 on opposite side.
5. Grease the wheel bearings.
2
1
2
4
3
5
3. Large OD flat washer
4. Cotter pin
5. Dust cover

Install Rear Wheels

1. Install wheel onto axle with valve stem to the
inside (Fig. 2).
Torque wheel bolts to 75-80 ft-lb (105-112 N . m).
2.
Figure 2
1. Wheel

Check Tire Pressure

Check front and rear tire pressure. See Operator's
Manual for specification.
Pressure: 20 psi (138 kPa) front and rear.
1
2
2. Wheel bolts