Table of Contents
Advertisement
Set-Up Instructions
DESCRIPTION
Operator's Manual
Engine Operator's Manual
Safety Booklet
Safety Video
Registration Card
Install Front Wheels
Note:
If wheels are already installed, refer to
Check Tire Pressure (below).
1.
Install shim washers onto axle.
2.
Install wheel onto axle with valve stem out.
3.
Slide the flat washer onto the axle. Insert cotter
pin through the axle and bend the ends of the pin
apart (Fig. 1). If cotter pin does not fit, remove
shim washer(s) as required.
4.
Push the hub cap (Fig. 1) onto the end of the
axle.
Figure 1
1. Flat washer
2. Cotter pin
5.
Repeat steps 1–4 on opposite side.
6.
Grease the wheel bearings until grease comes out
of bearing seal area.
2
QTY.
1
2
3
3. Hub cap
1
1
Read and watch before operating tractor.
1
1
1
Fill out and mail the card.
Install Rear Wheels
1.
Grease the axle to prevent corrosion.
2.
Slide spacer then wheel, with valve stem to the
outside, onto axle (Fig. 2).
3.
Slide key into keyway of axle and wheel hub
(Fig. 2).
4.
Slide shim washer(s) onto axle.
5.
Slide washer onto axle and secure with E-ring
(Fig. 2). If E-ring does not fit, remove shim
washer(s) as required.
6.
Press hub cap over washer (Fig. 2).
1779
Figure 2
1. Axle
2. Spacer
3. Wheel
4. Key
USE
1
2
3
4
5
6
5. Washer
6. E-rung
7. Cap
7
Advertisement
Table of Contents
