Table of Contents
Advertisement
Installation
Remove Carrier Frame
1.
Remove hairpin cotters and clevis pins from
mower hanger brackets and remove mower from
carrier frame (Fig. 1).
3
1
Figure 1
1. Mower Hanger Bracket
2. Clevis Pin
4
2
3. Hairpin Cotter
Install Castor Wheels
1.
Place spacer and (2) thrust washers on shaft and
slide the castor wheel into the mounting tube
(Fig. 2).
2.
Place (2) thrust washers on top of the fork and
secure with retaining ring (Fig. 2).
Note:
The location of the thrust washers on
each fork may need adjustment to
maintain a level deck.
3.
Grease the fitting on the carrier frame mounting
tube using No. 2 general purpose lithium base or
molybdenum base grease, refer to: Greasing and
Lubrication.
4.
Set the castor wheel tire pressure to 50 psi
(345 kPa).
1
4
5
3
6
Figure 2
1. Retaining ring
2. Thrust Washer (4)
3. Spacer
2
2
4. Carrier Frame Mounting
Tube
5. Grease fitting
6. Castor Wheel Fork
Advertisement
Table of Contents
