Maintenance; Recommended Maintenance Schedule(S) - Toro 08887 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition before you do any maintenance.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 400 hours
Every 800 hours
Every 1,500 hours
Important: Refer to your Engine Operator's Manual for additional maintenance procedures.
Maintenance Procedure
• Torque the wheel lug nuts.
• Change the engine oil and filter.
• Change the hydraulic filter.
• Check the engine oil level.
• Check the hydraulic fluid level.
• Check the tire pressure.
• Check the condition of the hydraulic lines and hoses.
• Inspect and clean the machine.
• Check the safety interlock operation
• Grease the front wheel bearings
• Check the battery fluid level and the cable connections.
• Change the engine oil and filter.
• Torque the wheel lug nuts.
• Grease the steering shaft and sprocket
• Replace the air filter.
• Change the hydraulic system oil and filter.
• Replace the spark plugs.
• Replace the fuel filter.
• Decarbon the combustion chamber.
• Adjust the valves and torque head.
• Check the engine RPM (at idle and full throttle).
• Drain and clean the fuel tank.
• Replace moving hoses.
• Replace the neutral and seat interlock switches.
20