Light Switch; Seat Adjustments - Toro 30873 Operator's Manual

when the engine is running. To lower the decks for service,
rotate the key to the ON position while sitting in the seat.

Light Switch

Press the lower edge of the switch (Figure 8) to turn on the
lights. Press the upper edge of the switch to turn off the lights.
Power Point
The power point (Figure 9) is used to power optional 12 volt
electrical accessories.
1. Power point
Bag Holder
Use the bag holder (Figure 9) for storage.

Seat Adjustments

Fore and Aft Adjusting Lever
Pull out on the lever to slide the seat fore or aft (Figure 10).
Seat Arm Rest Adjusting Knob
Rotate the knob to adjust the seat arm rest angle.
Seat Back Adjusting Lever
Move the lever to adjust the seat back angle (Figure 10).
Weight gauge
Indicates when the seat is adjusted to the weight of the
operator (Figure 10). Height adjustment is made by
positioning the suspension within the range of the green
region.
g020512
Figure 9
2. Bag holder
1. Weight gauge
2. Weight adjusting lever
3. Fore and Aft adjusting
lever
Weight Adjusting Lever
Adjust for operator weight (Figure 10). Pull up on the lever
to increase the air pressure and push down to decrease the air
pressure. The proper adjustment is attained when the weight
gauge is in the green region.
16
Figure 10
4. Seat back adjusting lever
5. Arm rest adjusting knob
(not shown-located under
arm rest)