THOMSON ROC8209 Operating Instruction page 19

the LCD remote can be programmed with. 2 different kind of
Timer, these are:
• A TV Sleep Timer. At the end of the set Timer period, the LCD remote
sends the Power command for the TV Mode device. The TV Sleep Timer
can be set for a period of 1-90 minutes. The "Zzz" symbol is displayed
when a TV Sleep Timer is set.
• 4 Timers that can send a sequence of up to 4 key commands at the preset
time. (i.e.: selection of a different channel); the Bell symbol is displayed on
the LCD screen.
a. Turn on the TV Mode device.
b. Press and hold Setup key until CODE SETUP is displayed (takes approximately 2–3 seconds).
c. Release Setup key.
d. Navigate to TIMER SETUP by pressing the Setup key 2 times. Press and release Okay key.
e. SLEEPTIM.TV is displayed. Press and release the Okay key.
f. TV-TIMER EINST is displayed. Press and release the Okay key.
h. MINUTEN EINST is displayed with "minutes" flashing. Use the Up/Down keys to set the minutes then press and
release the Okay key.
i. FERTIG will be displayed and the remote will remain in Setup, returning to the CODE SETUP screen.
j. Press and release Exit key to return to normal operation. Leave the remote pointing at the TV device.
a. Press and hold Setup key until CODE SETUP is displayed (takes approximately 2–3 seconds).
b. Release Setup key.
c. Navigate to TIMER SETUP by pressing the Setup key 2 times. Press and release Okay key.
d. SLEEPTIM.TV is displayed. Press and release the Okay key.
e. TV-TIMER AUS is displayed. Press and release the Okay key.
f. " AUS BEST. " is displayed. Press and release the Okay key.
g. " FERTIG " will be displayed and the remote will remain in Setup, returning to the " CODE SETUP " screen.
The LCD remote can be programmed with up to 4 Timers (Timer1, 2, 3 & 4).
Each Timer can be assigned up to 4 keys to activate at the set time (e.g. to
change SAT Mode channel to 123 at 22:35). The first key must always be a
Mode key. Subsequent keys cannot include Up, Down, Left, Right, OK, Exit,
Setup or any Mode key. Timers can only be set to activate within the following
24-hour period. Timers are automatically cleared after activation. The "Timer
Bell" symbol is displayed when any Timer is set.
(Note the Timer must be cleared first if it was previously set – see To Clear a Timer below)
a. Press and hold Setup key until CODE SETUP is displayed (takes approximately 2–3 seconds).
b. Release Setup key.
c. Navigate to TIMER SETUP by pressing the Setup key 2 times. Press and release Okay key.
d. SLEEPTIM.TV is displayed.
e. Navigate to TIMER X SETUP (where "X" is 1, 2, 3 or 4). Press and release the Okay key.
f. TimerX EINST is displayed. Press and release the Okay key.
g. TimerX ZEIT? is displayed with the "hours" flashing. Use the Up/Down keys to set the hours then press and
release the Okay key.
h. The "minutes" will be flashing. Use the Up/Down keys to set the minutes then press and release the Okay key.
i. TIMERX Mod.? is displayed. Press and release the desired Mode key (TV, VCR, DVD, etc.).
j. TIMER X EING1 is displayed. Press and release the first key required. If only one key is required, press and
release Okay at this point – go to Step "ml" below.
Timer Setup Options
To set a TV Sleep Timer
(no "Zzz" in normal display)
To clear a TV Sleep Timer
("Zzz" in normal display)
Setting and Clearing Timers
To set a Timer
15