Fuse; Headlights - Toro 73547 Wheel Horse 520Lxi Operator's Manual

4. Install the replacement transaxle filter to the
filter adapter. Turn the filter clockwise until the
rubber gasket contacts the filter adapter, then
tighten the filter an additional 3/4 turn (Fig. 51).
5. Fill the transaxle with the proper type of new oil;
refer to Changing/Draining Transaxle Fluid,
page 40.
Cleaning the Power Steering Filter
The power steering filter should be cleaned initially at
50 hours, then at 200–hour intervals thereafter. Please
have your Authorized Service Dealer clean the filter.

Fuse

Service Interval/Specification
The electrical system is protected by fuses. They
require no maintenance. However, if a fuse blows,
check the component and circuit for a malfunction or
short. To replace a fuse, pull it out of the fuse box
(Fig. 52).
1
2
3
4
Figure 52
1. F1; main–30 amp
2. F2; regulator–25 amp
3. F3; dash, interlock, and
cruise control–10 amp
m–3316
4. F4; headlights and
taillights–10 amp

Headlights

Specification: Bulb # 1156 Automotive Type
Removing the Bulb
1. Disengage the power take off (PTO), set the
parking brake, lower the attachment lift, and turn
the ignition key to "STOP" to stop the engine.
Remove the ignition key.
2. Open the hood. Pull the wire connectors off both
bulb holder terminals.
3. Rotate the bulb holder 1/4 turn counterclockwise
and remove it from the reflector (Fig. 53).
4. Push and rotate the bulb counterclockwise until
it stops (approx. 1/4 turn) and remove the bulb
from the bulb holder (Fig. 54).
5
3
2
4
Figure 53
1. Bulb holder
2. Reflector
3. Tabs
Maintenance
5
1
4
4. Slots
5. Terminals
41