Headlights And Taillights; Positioning The Tilt Steering Wheel; Using The Cruise Control - Toro 73547 Wheel Horse 520Lxi Operator's Manual

Operation

Headlights and Taillights

The headlights and taillights are turned on by turning
the ignition key to the LIGHTS position. They can be
turned on even if the engine is not running. Remove
the ignition key when leaving the machine unattended
so that the headlights cannot be turned on and
discharge the battery.
Figure 23
1. Lights
Positioning the Tilt Steering
Wheel
The steering wheel has four tilt locations. Position the
steering wheel where you have the best control of the
machine and are most comfortable.
1. Lift the tilt lever to release the lock (Fig. 24).
2. Move the steering wheel to a comfortable
position; then release the lever to lock it in place.
24
1. Tilt lever
1

Using the Cruise Control

The cruise control is a switch (Fig. 25) on the right
m–3312
fender that maintains a set traction control position
without foot pressure. The cruise control only
operates when moving forward.
1. Cruise control
Engaging the Cruise Control
1.
1
Figure 24
Figure 25
Begin driving the tractor; refer to Driving
Forward or Backward, page 21. While holding
your foot steady on the traction control pedal,
push the cruise control switch (Fig. 25) to the
"SET" position. This locks the traction control in
position and your foot can then be removed from
the traction control. A constant pedal position
will be maintained.
2
m–3259
2. Steering wheel
1
m–3313