Installation Location; Indoor Unit; Outdoor Unit - Trane R-410A Installation Manual

Indoor Unit

Adequate Support!
Wall structure must be adequate to support the weight of the unit. Failure to ensure
adequate structural support could result in unit falling from its location which could
result in death, serious injury, or equipement or property-only damage.
1.
2.
3.
4.
5.
6.
7.

Outdoor unit

Adequate Support!
Wall structure must be adequate to support the weight of the unit. Failure to ensure
adequate structural support could result in unit falling from its location which could
result in death, serious injury, or equipement or property-only damage.
1.
2.
3.
4.
5.
6.
NOTICE
Installing the unit in one of the following locations could result in unit malfunction:
•
•
•
•
•
8

Installation location

WARNING
The air inlet and outlet should be far away from anything that could prevent the air from
reaching all parts of the room.
Select a location where it is easy to drain the condensing water and connect to the outdoor
unit;
Keep the indoor unit far away from heat sources, vapor and inflammable gas;
Be sure that the installation of the indoor unit conforms to the installation dimension
diagram;
Be sure to leave enough space to allow access for routine maintenance; clearance between
the indoor unit and the floor should
Install in a location where the
such as television, audio devices etc.;
Select location where air filters can be easily removed
WARNING
Select a location from which noise and air discharge by unit will not annoy neighbors.
Select a location where there is sufficient ventilation.
Make sure the air inlet and outlet are not blocked by any obstacles.
Select a location capable of supporting the weight and vibration of the outdoor unit, and
where installation work can be carried out safely.
Select a location away from flammable gas or gas leaks.
Make sure that the installation of the outdoor unit conforms to the installation dimension
diagram.
Places where oil (machine oil) is used
Seaside/places with high level of salt in the air.
Places with high level of sulfur gas such as areas with hot springs.
Places where high-frequency waves are generated by radio equipment, welders and medical
equipment.
Other unusual places where unit operation may be altered.
be more than 7 feet.
unit is more than 3 feet aw ay from other electric appliances
MS-SVN25A-EN