Drive Belt - BOMBARDIER Outlander 400 Operator's Manual

1
V07C09Y
1. Bleeding screw
2. Engine temperature sensor
Drain the system completely and rein-
stall the coolant drain plug.
Pinch hose between radiator and ther-
mostat housing with a large hose
pincher (P/N 529 032 500) or an equiv-
alent.
CAUTION: Do not use vise-grip pli-
ers to pinch hose.
2
V07C0AY
1. Hose pincher
Fill the radiator until the coolant comes
out by the thermostat housing hole.
Install the bleeding screw then re-
move the hose pincher.
Complete the radiator filling.
Check the level in the coolant reservoir
and refill if necessary.
Run engine at idle with the radiator cap
off. Slowly add coolant if necessary.
At this point, wait until engine reach-
es normal operating temperature. De-
press the throttle lever two or three
times; then add coolant if required.
Install radiator cap. Inspect all connec-
tions for leaks and check coolant level
in the reservoir.

Drive Belt

See an authorized Bombardier ATV
dealer to check the width and the con-
dition of drive belt.
_____________________
1
109