BOMBARDIER Outlander 400 Operator's Manual page 105

A: ADJUST
C: CLEAN
I: INSPECT
L: LUBRICATE
R: REPLACE
T: PROCEED WITH TASK
PART/TASK
FUEL
(2)
Air filter
Fuel lines and connections
Fuel tank strainers
Carburetor
Carburetor valve piston
ELECTRICAL
(5)
Spark plug
Battery connections
Wiring harnesses, cables and lines
Condition of ignition switch, start button
(2)
and engine stop switch
Condition of lighting system (HI/LO
intensity, brake lamp, headlamp aiming,
(2)
etc.)
Winch
DRIVE TRAIN
Drive shaft boots and protectors
Drive shaft joints
Rear propeller shaft joint
Wheel bearing condition
Front/rear differentials
(oil level, seals and vents)
PERIODIC MAINTENANCE CHART
INITIAL INSPECTION 10 H OR 30 DAYS OR 300 KM (185 mi)
(To be performed by an authorized BRP ATV dealer. The initial
maintenance is very important and must not be neglected.)
25 H OR 750 KM (470 mi)
(4)
C R
I
A
T
I I
I
I
I
Refer to ATV Winch
Operator's Manual
(2)
I I
I
I L
I I
_____________________
50 H OR 1500 KM (930 mi)
100 H OR 1 YEAR OR 3000 KM (1865 mi)
200 H OR 2 YEARS OR 6000 KM (3730 mi)
TO BE PERFORMED BY
(4)
Customer
I Dealer
R Dealer
A Dealer
I Dealer
R Customer
Customer
I Dealer
I Customer
I Customer
Customer
Customer
Dealer
(4)
Dealer
I Customer
R Dealer
LEGEND
(2) Pre-ride inspection item.
(4) More often under severe use
such dusty area, sand, snow,
wet or muddy conditions.
(2) Pre-ride inspection item.
(5) Make sure the spark plug is
correctly gapped.
(2) Pre-ride inspection item.
(4) More often under severe use
such dusty area, sand, snow,
wet or muddy conditions.
103