Steering System; Throttle Cable Lubrication - BOMBARDIER rally 200 Operator's Manual

STEERING SYSTEM

Throttle Cable Lubrication

The throttle cable must be lubricated with sil-
icone cable lubricant (P/N 293 600 041) or
equivalent.
WARNING
Always use a silicone-based lubricant. Us-
ing another lubricant (like water-based lu-
bricant) could cause the throttle lever/ca-
ble sticking or stiffness.
Open the throttle lever housing.
1. Remove screws
Slide the rubber protector to expose the cable
adjuster.
Unscrew the lock nut of the cable adjuster
then screw in the adjuster to release the cable
tension.
1. Rubber protector
2. Cable adjuster
Remove the cable from the throttle lever.
V06I04Y
1. Throttle handle housing
2. Throttle cable
NOTE: Slide cable in clip slot and remove the
end of cable from clip.
Remove the carburator cap on top of the car-
burator. Place the carburator cap far from car-
burator body.
Install the cable luber (P/N 529 035 738) on
the cable.
Insert the needle of spray can in the cable lu-
ber hole.
WARNING
Always wear eye protection and gloves
when you lubricate a cable.
NOTE: Place a rag around the cable luber to
prevent the lubricant splash.
Add lubricant until it runs out at carburator end
of the throttle cable.
Let the cable hang during approximately
15 minutes or until no lubricant flows out of
cable.
Reinstall carburator cap.
Reinstall and adjust the cable.
2 1
113