Environmental Protection - Metabo PowerMaxx 12 Original Instructions Manual

17027022_0811 PowerMaxx 12.book Seite 11 Montag, 1. August 2011 8:45 08
7.3 Setting the direction of rotation, engag-
ing the transporting safety device
(switch-on lock)
Do not activate rotation selector switch (5)
unless the motor has completely stopped!
Actuate the rotation selector switch (direction of
rotation setting, transporting safety device) (5).
See page 3 (please unfold).
R = Clockwise setting
L = Counter-clockwise setting
0 = Middle position: transportation safety
device
(Switch-on lock) set
7.4 Selecting gear stage
1st gear (low speed,
particularly high speed, preferable for
screwing)
2nd gear (high speed, preferable for drilling)
7.5 Setting torque control,
drilling
Turn selector barrel (torque, drilling) (3).
1...6 = Torque setting (with torque control) -
intermediate positions are also possible.
= Drilling stage setting (max. torque,
without torque control)
To avoid motor overloading, do not lock
the spindle.
7.6 Switching power tool on/off, setting
speed
To start the machine, press the trigger (6). The
speed can be changed by pressing in the trigger.
7.7 LED lights
For working on dimly lit areas. The LED lights (2)
light up when the machine is switched on.
8 Tips and Tricks
If you are working with long screw bits or bit
holders, we recommend the use of the bit
clamping bush (1) provided or the bit clamping
brush 6.31281 available as an accessory (see
accessories Chapter).
Drilling
Preferably in 2nd gear (high speed).
Screws
Preferably in 1st gear (low speed) and with torque
control.
Screws in areas that are hard to access
The angle screwdriver attachment (see Accesso-
ries chapter) greatly facilitates work on areas that
are difficult to access.
Thread tapping
Lubricate the dies.
Select 1st gear (low speed).
Adjust torque control.
9 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Quick-clamping chuck.
Fitting: unscrew protective cap (1). Screw the
quick-clamping chuck onto the spindle
thread. The quick-clamping chuck can be
tightened (and released again) with an open-
jawed spanner.
B Angle screwdriver attachment.
C Battery pack
D Battery charger
E Bit clamping bush
F Bit box
10 Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
If you have Metabo electrical tools that require
repairs, please contact your Metabo service
centre. For addresses see www.metabo.com.
You can download spare parts lists from
www.metabo.com.

11 Environmental Protection

Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Battery packs must not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact
with water!
ENGLISH
ENG
11