Setup; Assembling And Unfolding The Handle - Toro 20382 Operator's Manual

Setup

1
Assembling and Unfolding the
Handle
No Parts Required
Procedure
WARNING
Assembling and unfolding the handle improperly
can damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when assembling and
unfolding the handle.
• Ensure that the cables are routed to the outside
of the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Raise the rear of the machine housing to its highest
cutting height setting by moving the 2 rear cutting
height levers all the way forward. Refer to Adjusting
the Cutting Height (page 9).
2. Attach the handle ends to the machine housing with
2 washers and 2 handle bolts (Figure 3), but do not
tighten the handle bolts.
1. Washer
2. Handle bolt
Important: Route the cables to the outside of the
handle (Figure 3).
3. Rotate the handle rearward (Figure 4).
G017457
Figure 3
3. Handle end
4. Lock the handle at your desired height. Refer to
Adjusting the Handle Height (page 9).
5. Torque the handle bolts to 120 to 160 in-lb (14 to 17
N-m).
6. Adjust the cutting height. Refer to Adjusting the
Cutting Height (page 9).
5
G017479
Figure 4