Removing The Machine From Storage - Toro 20382 Operator's Manual

2. To unfold the handle, refer to 1 Assembling and
Unfolding the Handle (page 5).
Removing the Machine from
Storage
1. Check and tighten all fasteners.
2. Remove the spark plug and spin the engine rapidly
using the starter to blow excess oil from the cylinder.
3. Install the spark plug and tighten it with a torque
wrench to 15 ft-lb (20 N-m).
4. Perform any needed maintenance procedures; refer to
Maintenance (page 15).
5. Check the engine oil level; refer to Checking the Engine
Oil Level (page 8).
6. Fuel the fuel tank with fresh gasoline; refer to Filling
the Fuel Tank (page 7).
7. Connect the wire to the spark plug.
G017492
Figure 38
19