16
ELECTRICAL SYSTEM
16.12
Changing the turn signal bulb
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
–
Remove the screw on the front of the turn signal housing.
–
Carefully remove diffuser
–
Press bulb
it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new bulb carefully into the socket and turn it clockwise until it stops.
M00854-10
Turn signal (RY10W / socket BAU15s) (
–
Check the turn signal to make sure it is functioning properly.
–
Position the diffuser.
Info
Hook in projection
–
Insert the screw and first turn it counterclockwise until it engages in the thread. Tighten
the screw slightly.
.
carefully into the socket, turn it counterclockwise by about 30°, and pull
at recess
p. 237)
.
198