KTM 1290 SUPER ADVENTURE Owner's Manual page 124

13 SERVICE WORK ON THE CHASSIS
Main work
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning the adjusting screws
Guideline
Chain tension
Turn adjusting screws
right chain adjusters
rear wheel is then correctly aligned.
Info
The upper part of the chain must be taut.
Chain wear is not always even, so you should check the setting at different chain
positions.
–
Tighten nuts
–
Make sure that chain adjusters
–
Tighten nut
S00734-10
Guideline
Nut, rear wheel spindle
Info
Chain adjusters
Finishing work
–
Remove the vehicle from the center stand. (

.
 .

on the left and right so that the markings on the left and

are in the same position relative to reference marks

.

are resting against adjusting screws

.
M25x1.5

can be turned through 180°.

on the left and right.
40... 45 mm (1.57... 1.77 in)

90 Nm Thread greased
(66.4 lbf ft)
p. 113)
122

. The
.