Remove The Front Bezel - HP ProLiant ML10 Maintenance And Service Manual

Place the server on its side.
4.
Unfasten the T-15 screw securing the access panel, and then slide the panel towards the rear of the
5.
server.

Remove the front bezel

The front bezel must be opened to access the drive cage and media bays. The bezel must remain closed
during normal server operation.
Press the Power On/Standby button.
1.
The server powers down and enters standby mode. The system power LED changes from green to
2.
amber. Power is still applied to the server.
Disconnect the power cord from the power source.
3.
Disconnect the power cord from the server.
4.
Remove the access panel (on page 23).
5.
Removal and replacement procedures 24