Ambient Temperature Sensor Cable - HP ProLiant ML10 Maintenance And Service Manual

Remove the access panel (on page 23).
5.
Remove the front bezel (on page 24).
6.
Disconnect the front I/O cable connectors from the system board.
7.
Remove the front I/O module:
8.
Push the latch above the front I/O module.
a.
Slide the assembly to the left and remove the entire assembly out of the front I/O module chassis
b.
opening.
To replace the component, reverse the removal procedure.

Ambient temperature sensor cable

To remove the component:
Press the Power On/Standby button.
1.
Removal and replacement procedures 30