Table of Contents
Advertisement
against the slide shoes). Make certain the slide
shoes are adjusted to be level.
•
To remove the shave plate, remove slide shoe as
well as the carriage bolts, belleville washers and
hex nuts which attach shave plate to the snow
thrower housing. For location of shave plate and
carriage bolts, see Figure 15.
•
Reassemble the new shave plate, making sure
heads of carriage bolts are to the inside of the
housing.
•
Reinstall the skid shoes and tighten securely.
Replacing Belts
To remove and replace either the auger belt or the drive
belt, follow the steps below and then proceed to the
specific steps listed under respective sub-headings.
•
Disconnect the chute crank assembly at the
discharge chute end by removing the hairpin clip
and the two flat washers.
Flat
Belt Cover Bolts(3)
Hairpin
Washers
Clip
(do not remove)
Engine Pulley
Shoulder Bolt
Figure 16
•
Remove the plastic belt cover, located near the
engine, by removing the three self-tapping screws
and flat washers that secure it. See Figure 16.
Belt Cover
Upper Bolt
Shoulder Bolt
(remove)
•
Remove the large shoulder bolt and washer on the
left hand side of the engine pulley. See Figure 16
Auger Belt
•
Remove the cotter pin and washer from the ferrule
in order to disconnect the auger idler rod from the
brake bracket assembly. See Figure 17.
•
Slip the auger control belt (the front belt) off the
engine pulley.
Engine
Pulley
Auger Idler
Rod
Ferrule
Brake Bracket
Assembly
Z Fitting
•
Pull the brake bracket assembly towards the cable
guide roller and unhook the auger cable "Z" fitting.
•
Remove the upper bolts and lock washers which
attach the auger housing assembly to the frame
assembly using a 9/16" wrench. See Figure 16.
•
Separate the auger housing from the frame
assembly by tilting the housing forward and pulling
up the handles.
•
Using a 1/2" wrench, remove the hex screw and
belleville washer from the center of the pulley on
the auger housing. Lift the brake bracket assembly
out of the pulley groove and remove the pulley. Be
careful not to lose the key. See Figure 18.
Brake Bracket Assembly
Belt Keepers
•
Remove and replace auger belt inside belt keepers.
14
Auger Control
Belt
Cable Roller
Guide
Figure 17
Auger Belt
Idler Pulley
Auger Pulley
Hex Screw
Belleville Washer
Figure 18
Hide quick links:
Advertisement
Table of Contents
