Maintaining Your Snow Thrower - Cub Cadet 1333 SWE Operator's Manual

Trigger Cables
Shift Arm
Auger Actuator
Bracket
Hex Nut
And Cupped
Washer
Figure 10
• Retighten the jam nut to secure the cable when
correct adjustment is reached.
• Reassemble the frame cover.
NOTE: If you placed plastic film under the gas cap, be
certain to remove it before operating the snow thrower.
Shift Rod
To adjust the shift rod, proceed as follows:
• Remove the hairpin clip and flat washer from the
shift handle under the handle panel.
• Place shift lever in sixth (6) position or fastest
forward speed.
• Push shift arm assembly down as far as it will go.
• Rotate the ferrule up or down on the shift rod as
necessary until the ferrule lines up with the upper
hole in the shift lever. See Figure 11.
• Insert ferrule from the left side of the snow thrower
into the upper hole.
• Reinstall the hairpin clip and the washer.
Make certain to check for correct
IMPORTANT:
adjustment of the shift rod as instructed under Final
Adjustments in the Assembly Section, before operating
the snow thrower.
SECTION 6: MAINTAINING YOUR SNOW THROWER
WARNING:
ing, or inspecting, disengage all clutch
levers and stop engine. Wait until all mov-
ing parts have come to a complete stop.
Disconnect the spark plug wire and
ground it against the engine to prevent
unintended starting.
Drive Actuator
Bracket
Hex Gear Shaft
Rubber
Friction
Wheel
Drive Plate
Before lubricating, repair-
Hairpin Clip
Flat Washer
Shift Arm
Skid Shoe Adjustment
The space between the shave plate and the ground can
be adjusted by raising or lowering the skid shoes. Refer
to Skid Shoe Adjustment in the Assembly Section.
Auger Control Adjustment
Refer to the information
Adjustments in the Assembly Section to adjust the
auger control.
Chute Assembly
The distance snow is thrown can be adjusted by
adjusting the angle of the chute assembly. Refer to the
"Know Your Snow Thrower" section.
The remote chute control cables have been pre-
adjusted at the factory. Move the remote chute lever on
the control panel back and forward to adjust angle of
the chute assembly.
General Recommendations
• Always observe safety rules when performing any
maintenance.
• The warranty on this snow thrower does not cover
items that have been subjected to operator abuse
or negligence. To receive full value from the
warranty, operator must maintain the snow thrower
as instructed in this manual.
• Some adjustments will have to be made
11
Shift Lever
Ferrule
Upper Shift Rod
Clutch Rod
Connector
Lower Shift Rod
Figure 11
found under Final