Teledyne Linea GigE 2K User Manual page 82

Line 2
Line 3
Line 4
Line 3 Pulse Start
Line 4 Pulse Start
Line 5 Pulse Start
Line 6 Pulse Start
Events Overflow
Event Notification
Off
On
GigEVisionEvent
Event Line Activation
Rising Edge
Falling Edge
Any Edge
Event Statistic Selector
Start of Acquisition
End of Acquisition
Start of Frame
End of Frame
Valid Frame Trigger
Invalid Frame Trigger
Image Lost
Invalid Line Trigger
Line Trigger Overlap
Event Statistic Count
Event Statistic Count
Reset
Acquisition Start Data
80  Operational Reference
Line3PulseStart
Line4PulseStart
Line5PulseStart
Line6PulseStart
eventsOverflow
EventNotification
GigEVisionEvent
eventLineActivation
RisingEdge
FallingEdge
AnyEdge
eventStatisticSelector
AcquisitionStart
AcquisitionEnd
FrameStart
FrameEnd
ValidFrameTrigger
InvalidFrameTrigger
ImageLost
InvalidLineTrigger
LineTriggerOverlap
eventStatisticCount
eventStatisticCountReset
EventAcquisitionStartData
Line2 Event sent on control channel when a state
change occurs on line 2.
Line3 Event sent on control channel when a state
change occurs on line 3.
Line4 Event sent on control channel when a state
change occurs on line 4.
Event sent on control channel when a pulse is
generated on line 3.
Event sent on control channel when a pulse is
generated on line 4.
Event sent on control channel when a pulse is
generated on line 5.
Event sent on control channel when a pulse is
generated on line 6.
Event sent on control channel when all previous
active events have been disabled because the
camera cannot send them fast enough, generating
an internal message overflow. All required events
must be re-enabled manually.
Enable Events for the event type selected by the
EventSelector feature.
Off The selected event is disabled.
On The selected event will generate a software event.
The selected event will generate a software event
for SFNC 1.x compatibility.
Controls the activation of the line event. This is
only used for input line configurations. Output
lines only generate events on pulses start.
The event is generated on the line rising edge.
The event is generated on the line falling edge.
The event is generated on any line edge.
Selects which Event statistic to display.
Event sent on control channel on acquisition start.
Event sent on control channel on acquisition end.
Event sent on control channel on an Active Frame.
This occurs with the start of the exposure delay.
Event sent on control channel on an Active Frame
end.
Event sent on control channel when a valid frame
trigger is generated.
Event sent on control channel when a frame
trigger occurs in an invalid Trigger region.
Therefore the trigger is rejected and no frame
acquisition occurs.
Event sent on control channel when an image is
lost due to insufficient memory.
Event sent on control channel when a line trigger
occurs in an invalid Trigger region. Therefore the
trigger is rejected and no frame acquisition
occurs.
Event sent on control channel when a line trigger
occurs in an invalid trigger region and was
delayed by the camera into a valid region.
Display the count of the selected Event.
Reset the count of the selected Event.
Data of the acquisition start event.
1.00
Expert
1.00
Expert
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Guru
Linea GigE Series Camera