Table of Contents
Advertisement
Pulse on: End of Acquisition
Pulse on: End of Timer 1
Pulse on: End of Timer 2
Pulse on: End of Counter 1
Pulse on: End of Counter 2
Pulse on: Input Line 1 Event
Pulse on: Input Line 2 Event
Pulse on: Input Line 3 Event
Pulse on: Input Line 4 Event
Pulse on: Software
Command
Frame Trigger
Frame Valid
Exposure Active
Line Active
Smart Strobe Active
Output Line Pulse Signal
Activation
Rising Edge
Falling Edge
Any Edge
Output Line Pulse Delay
Output Line Pulse Duration
Output Line Software Latch
Control
Off
Output Line Value
Active
Inactive
Line Status All
40 Operational Reference
PulseOnEndofAcquisition
PulseOnTimer1End
PulseOnTimer2End
PulseOnCounter1End
PulseOnCounter2End
PulseOnInput1
PulseOnInput2
PulseOnInput3
PulseOnInput4
PulseOnSoftwareCmd
FrameTriggerActive
FrameActive
ExposureActive
ReadoutActive
SmartStrobeActive
outputLinePulseActivation
RisingEdge
FallingEdge
AnyEdge
outputLinePulseDelay
outputLinePulseDuration
outputLineSoftwareLatchControl
outputLineValue
Active
Inactive
LineStatusAll
Generate a pulse when the AcquisiontStop event
occurs
Generate a pulse on the TimerEnd 1 event.
Generate a pulse on the TimerEnd 2 event.
Generate a pulse on the CounterEnd 1 event.
Generate a pulse on the CounterEnd 2 event.
Generate a pulse on the Input signal 1 event
Generate a pulse on the Input signal 2 event
Generate a pulse on the Input signal 3 event
Generate a pulse on the Input signal 4 event
Generate a pulse on the Input of a Software
Command
Generate a signal that is active when the frame
trigger is active
Generate a signal that is active when the Frame is
active
Generate a signal that is active when the
Exposure is active
Generate a signal that is active when the line
valid is active
Generate a signal that is active when the Readout
or the ExposureDelay are active. The smart
strobe only works when triggerLineCount is
greater than 1
Specifies the input line activation mode to trigger
the OutputLine pulse.
Specifies that the trigger is considered valid on
the rising edge of the source signal.
Specifies that the trigger is considered valid on
the falling edge of the source signal.
Specifies that the trigger is considered valid on
the falling or rising edge of the source signal.
Sets the delay (in µs) before the output line pulse
signal. Applicable for the OutputLineSource
feature. Note, the LineMode feature must be set
to output.
Sets the width (duration) of the output line pulse
in microseconds.
When Off, the selected output line is set with the
value in Output Line Value. (RO)
Off
Output pin state set by outputLineValue.
Sets the output state of the selected Line if the
outputLineSoftwareLatchControl = OFF.
OutputLineSource must be SoftwareControlled. If
the outputLineSoftwareLatchControl = Latch , the
state of the pin will change with the
outputLineSoftwareCmd command.
Sets the Output circuit to close
Sets the Output circuit to open
Returns the current status of all available line
signals, at time of polling, in a single bitfield. The
order is Line1, Line2, Line3, ... (RO)
1.00
Beginner
DFNC
1.00
Beginner
DFNC
1.00
Beginner
DFNC
1.00
Guru
DFNC
1.00
Beginner
DFNC
1.00
Expert
Linea GigE Series Camera
Advertisement
Table of Contents
