Threading The Machine; Bobbin Winding - Baby Lock Jazz BLMJZ Instruction And Reference Manual

THREADING THE MACHINE

Bobbin Winding

WINDING THE BOBBIN
1.Place a spool of thread onto the spool pin with
thread winding off counterclockwise and slide
the appropriate spool cap on spool pin until it's
against the spool of thread.
2.Pass thread through the thread guide as shown.
3.Pass thread through the bobbin winder thread
guide.
4.Guide thread from bobbin winder thread guide
through pretension disc as shown.
5.Insert thread through hole in bobbin from inside-out.
6.Place the bobbin on bobbin winder shaft and push
to the right to engage bobbin winder.
7.Hold the end of thread and start the machine.
Thread guide
CAUTION
If the spool of thread is not correctly placed, the thread may
tangle on the spool.
Make sure you follow the instructions carefully. If you do not cut
the excess thread completely before winding the bobbin, when
the bobbin thread runs low it may tangle around the bobbin and
cause the needle to break.
Pretension disc
8.After the bobbin winds a few turns, stop the
machine and cut the thread as close to the hole as
possible.
9.Start the machine again by pressing foot control
and wind bobbin at medium speed.
10.The bobbin winding will stop when bobbin is full.
11.Push the bobbin and shaft to the left.
Remove the bobbin from the shaft and cut the
thread.
5
-10-
6 7
8 9
11
10