KTM 50 SX Mini Owner's Manual page 41

MAINTENANCE WORK ON THE CHASSIS
–
Check the chain sliding guard for wear.
» If the ridge is worn down to the level of the main corpus:
–
Change the chain sliding guard.
–
Check the chain sliding guard for tightness.
» If the chain sliding guard is loose:
–
Tighten the chain sliding guard.
Guideline
Screw, chain sliding piece
401035-01
–
Check the chain sliding piece for wear.
» If the lower bolt edge of the chain is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check the chain sliding piece for tightness.
» If the chain sliding piece is loose:
–
Tighten the chain sliding piece.
Guideline
Screw, chain sliding piece
401036-01
–
Check the chain guide for wear.
» If the chain guide is worn down to the top or bottom edge:
–
Change the chain guide.
401034-01
–
Check the chain guide for tightness.
» If the chain guide is loose:
–
Tighten the chain guide.
Guideline
Remaining screws, chassis
–
Install the engine sprocket cover.
(50 SX)
100897-01
–
Install the chain guard. (
–
Remove the motorcycle from the lift stand. (
x
M6
x
M8
x
M6
( p. 37)
x
p. 36)
p. 25)
39
3 Nm
(2.2 lbf ft)
15 Nm
(11.1 lbf ft)
10 Nm
(7.4 lbf ft)