KTM 125 Duke Owner's Manual page 117

13 WHEELS, TIRES
–
Pull the rear wheel back and mount wheel spindle
adjuster
–
Mount nut
–
Push the rear wheel forward so that the chain adjusters are on the screws, and
tighten nut
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and
right chain adjusters must be in the same position relative to the reference
marks
Nut, rear wheel spindle
(Option: With ABS)
–
Check the rear hub rubber dampers.
B01606-11
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
–
Clean and grease the shaft seal rings
Long-life grease (
–
Clean the thread of the wheel spindle and nut
–
Clean the fixing locations on the brake caliper support and swingarm.
B01394-10
 .
Info
Mount the left and right chain adjusters

and washer.

.

.
Change the wheel bearing. x
p. 184)
 with the washer and chain

in the same position.
M14x1.5
( p. 117)
x
 
and mating surfaces

.
115
90 Nm
(66.4 lbf ft)
of the spacers.