KTM 690Duke EU Owner's Manual page 84

MAINTENANCE WORK ON CHASSIS AND ENGINE
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Replace the wheel bearing.
–
Clean and grease the thread of the wheel spindle and screw
Long-life grease (
–
Lift the front wheel into the fork, position it, and insert the wheel spindle. Mount and
tighten screw
Guideline
700155-11
Screw, front wheel spindle
–
Position the brake caliper and check that the brake linings are seated correctly.
–
Position spacers
–
Operate the hand brake lever repeatedly until the brake linings lie on the brake disc and
there is a pressure point. Fix the hand brake lever in the activated position.
The brake caliper straightens.
–
Fully tighten screws
Guideline
Screw, front brake caliper
–
Remove the fixation of the hand brake lever.
x
p. 173)
.

. Mount screws but do not tighten yet.
 
.

M10x1.25
.

M24x1.5 40 Nm
(29.5 lbf ft)
45 Nm Loctite ®
(33.2 lbf ft)
82
243™