KTM 690Duke EU Owner's Manual page 70

MAINTENANCE WORK ON CHASSIS AND ENGINE
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
Guideline
Chain tension
Turn the left and right adjusting screws
chain adjusters
rear wheel is then correctly aligned.
Info
The upper chain section must be taut.
Chain wear is not always even, so you should check this setting at different
chain positions.
–
Tighten nuts
–
Make sure that the chain adjusters
–
Tighten nut
Guideline
Nut, rear wheel spindle
100131-10
Info
The wide adjustment range of the chain adjusters (30 mm (1.18 in)) enables
different secondary transmissions with the same chain length.
The chain adjusters
.

.

are in the same position relative to the reference marks

.

are installed correctly on adjusting screws

.

can be turned through 180°.

on the left and right.

5 mm (0.2 in)
so that the markings on the left and right

M25x1.5 90 Nm
(66.4 lbf ft)
68
. The

.
