Nokia RX-44 Service Manual page 144

6. If the name of the WLAN test Box (Default) appears on the list under Scan results, the RX-44 is OK (see
following figure).
After scanning signal level should be 173 +/- 6
Otherwise repeat testing 3-4 times as follows:
7. If the name was not on the list:
i Choose Power state: Off, and wait 5 seconds
ii Choose Power state: On, and wait 5 seconds
Jump to task 5.
8. If you still can't find the name of the WLAN test Box (Default) on the list under Scan results, the RX-44 is
not OK
Note: Note: Local WLAN environment may affect test results, especially if there are many WLAN
access points nearby.
Known issue: If you manage to scan SB-7 with RX-44 and remove power from SB-7 and press scan again,
SB-7 is still found. You have to wait for 1 minute after SB-7 power down before scanning in order that
scan results history is deleted from RX-44.
Page 5 –18 COMPANY CONFIDENTIAL
Copyright © 2007 Nokia. All rights reserved.
RF Troubleshooting and Tuning
RX-44
Issue 1