Table of Contents
Advertisement
"
I.D. CONDUIT
Figure 2-2.
Mounting Holes Location Diagram
9
H
NPT FOR
35/4"
Tl=t.aJ
/
-
a--+------_,
115VAC (optional) for
appropriate terminals for installation. Connect the flowmeter cable to the
FTB500 including shield.
"0" RING
REMOVABLE COVER
FTB500 should be placed in a convenient location with sufficient room
for easy opening of the enclosure Refer to Figure 2-2 for the mounting draw-
ing for the FTB500.
Drill appropriate mounting holes as required. Mount the unit to the panel.
Refer to Figure 2-3 for DC hookup or Figure 2-4 for
FTB500 MINI FLOW SIGNAL CONDITIONER
The
It is common to transmit the low level output signal from the flowmeter
several hundred feet through a shielded, twisted pair instrument cable.
Where a noisy environment is suspect, it is recommended that a pre-
amplifier be installed on or near the flowmeter to assure the preservation
of flow information from the flowmeter to the electronic measuring system.
Suitable accessory models are available from the manufacturer.
2.5
INSTALLATION OF THE
Advertisement
Table of Contents
