Level 1 Menu; Circular Flow Of Menus - Omega Platinum DP32Pt Quick Start Manual

TM
PLATINUM Series Meters Quick Start Guide
4.3

Level 1 Menu

Initialization Mode: These settings are rarely changed after initial setup. They include
INIt
transducer types, calibration, etc. These settings can be password-protected.
Programming Mode: These settings are frequently changed. They include Setpoints,
PRoG
Control Modes, Alarms, etc. These settings can be password-protected.
Operating Mode: This mode allows users to switch between Run Mode, Standby Mode,
oPER
Manual Mode, etc.
4.4

Circular Flow of Menus

The following diagram shows how to use the LEFT and RIGHT buttons to navigate around a menu.
Press the ENTER button on
oPER to select and enter RUN
Mode.
Press the LEFT and RIGHT
buttons to navigate around
the Operating Mode options.
oPER
RUN
Stby
PEAk
VALy
Figure 8 – Circular Flow of Menus.
PLATINUMTM Series Navigation
Press the UP button to
navigate back up a level.
It is possible to cycle through
any menu in both directions.
SP1
SP2
L.RST
10